Material Handling Power UNIT 2
Basic Description
This power unit attributes energy up gravity down circuit. Activate the begin solenoid to begin the motor to lift the machine. The lowing movement is activated through the solenoid valve with the decreasing velocity controlled by the stress compensated flow control valve. Items of this series is often extensively used in the industry of logistic devices for example fork lift, mini lift table, and so forth.
Special Notes
one. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic components concerned prior to mounting the energy unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst,which need to also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil transforming is needed after the preliminary one hundred operation hrs,afterwards the moment every 3000 hrs.
5. The electrical power unit should be mounted horizontally.

Materials Managing Power UNIT 1
General Description
This electrical power unit is made to the fork lift sector, consisting of remarkably effective gear pump, DC motor, manual raise and decrease valve, tank, ect. The up and down motion are controlled from the lever on the guide release valve, which can be outfitted with an electrical switch to activate the motor. The lowing speed is managed through the stress compensated movement handle valve.
Specific Notes
one. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean each of the hydraulic components concerned ahead of installation of the energy unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of charge of impurities, N46 hydraulic oil is advised .
four. Oil shifting is needed soon after the original a hundred operation hours, afterwards after every 3000 hours.
5. The energy unit shown is intended to be mounted horizontally.